Wiring your VBar

Pay attention when connecting the USB wire: Do not short circuit the connector for the Control Panel/Bluetooth Module!

Bluetooth-PIN: 1111
 

Connection of servos, devices:


Tail servo = Tail rotor servo
Channel 1...3 = Swashplate servos
Channel 4 = Swashplate servo 4 / Programmable for ESC/Throttle output (special use on 5.1 Gov. Pro)
Rudder/Aux2 = single I/O and power supply
Collective/ESC = single I/O and power supply
Aileron = single I/O and power supply
Elevator = single I/O and power supply
Aux = single I/O and power supply

 


CP = Control panel or bluetooth
Sensor = VBar sensor
Servo = single I/O - for Throttle servo on 5.1 Gov Pro only!
Sensor II = single I/O - for RPM sensor on 5.1 Gov Pro only!
Do not connect any power supply to the USB side of the VBar (e. g. no BEC, ESC with BEC, buffer battery, ...)
Make sure a throttle servo can not bind.
The connectors on the USB side are not capable of meeting or routing high power demands.

 
 


RX 1 = Satellite 1
RX 2 = Satellite 2
 
 

All here: brown/black wire pointing towards the upper (label) side.

 
 

Connectors for standard reciever:

Tail servo = Tail rotor servo
Channel 1...3 = Swashplate servos
Channel 4 = Swashplate servo 4 / Programmable for ESC/Throttle output (special use on 5.1 Gov. Pro)
Rudder/Aux2 = Rudder signal from RX
Collective/ESC = Collective signal from RX
Aileron = Aileron signal from RX
Elevator = Elevator Signal from RX
Aux = Gyro gain signal from RX
RX 1 = not used
RX 2 = not used
 

 

Connectors for single line (Jeti, Futaba RASST, Graupner HOTT) and Futaba S-Bus as well as Multiplex M-Link:

Tail servo = Tail rotor servo
Channel 1...3 = Swashplate servos
Channel 4 = Swashplate servo 4 / Programmable for ESC/Throttle output (special use on 5.1 Gov. Pro)
Rudder/Aux2 = additional out, can be used for ext. Gov
Collective/ESC = Throttle / ESC out
Aileron = not used
Elevator = not used
Aux = RX signal input
RX 1 = not used
RX 2 = not used
 

 

Connectors for Spektrum satellites:

Tail servo = Tail rotor servo
Channel 1...3 = Swashplate servos
Channel 4 = Swashplate servo 4 / Programmable for ESC/Throttle output (special use on 5.1 Gov. Pro)
Rudder/Aux2 = additional out, can be used for ext. Gov
Collective/ESC = Throttle / ESC out
Aileron = not used
Elevator = not used
Aux = not used
RX 1 = Satellite 1
RX 2 = Satellite 2