start && end > -1) { if (start > -1) { var res = data.substring(start, end); start = res.indexOf('>') + 1; res = res.substring(start); if (res.length != 0) { eval(res); } } cursor = end + 1; } } } //]]>
Hi Guys, I am trying to load 5.3, 6.0 and the VPlane and constantly getting this error: "Error at loading form ware option not available". The device is registered to me I have reset the firmware. Serial: 1410037237 Many Thanks Michaelby cagen - Questions V5
VBar NEO (Vlink) Blue I thought I found the problem last night. When I removed the previous throttle servo (Align DS 620) I had the voltage returned to the correct 6v. I have since connected a different throttle servo (Align DS 610) but the voltage went back to 5.2v. Even now when I remove the throttle servo (Align DS 610), the voltage stays at 5.2v. There are only 2 servos connected dby cagen - Café
Ignore my reply. I've done it by changing the reciever on the Neo via the software. Thank you guys very much. cagen Wrote: ------------------------------------------------------- > Hi Eddi, > > > > I know nothing about Macrocells and if I go into > the software for the Neo. You only have the > option to select either the VControl or the > Spektrum sats.by cagen - Setups
Hi Eddi, I know nothing about Macrocells and if I go into the software for the Neo. You only have the option to select either the VControl or the Spektrum sats. You can't select both. So here I am confussed unless going down the Macrocells route is easier?.. Many thenksby cagen - Setups
Hi Guys, I have recently purchased my first VController and had our club chairman help me set it up for my Trex 700N. Everything looks ok but the RX Voltage is not showing the correct voltage. I am using low voltage servos with a Gryphon Extreme Heli Regulator (see screenshot). The voltage is set correctly at 6.0v and using a tester from one of the ports on the regulator this shows the coby cagen - Café
Thanks a bunch guys. I'll try these when I get in from work tonight. Many thanksby cagen - Setups
I so hope there's someone out there that can help here. I'm looking for instructions or guidance to setup a buddy box between 2 VControllers on a Neo Vlink. I have a Trex 700n, VBar Neo Vlink, VControl and a Spektrum DX9. I have been searching for information on how to setup a VControl buddy box between two VControllers (the other belongs to a friend) or a VController and Spektrum DX9.by cagen - Setups
Thank you Rainer for the clarification on this. There have been old responses on this which made me have to ask the question. Hope this is clear to anyone else that is in the same position as me. By the way. What you mean by "a different control loop"?by cagen - VBar NEO (non VLink)
Hi Guys, I have had to purchase a new Neo since my crash a few weeks ago. Is it possible to transfer the pro licence from my Silverline to my new Neo? Many thanksby cagen - VBar NEO (non VLink)