Logo 800 with a Pyro 800-40L

I’m trying to find if this motor will work. I know you need to change some things around but I cannot find the thread. Can someone please provide the link so I can refer to it?

Hi,

even google does not spit out something useful, if I search only vstabi.info (google site:vstabi.info keyword(s)), but I'd guess, with the diameter of the bell, you'd probably need to go for the bigger main gear from the 800 XX (and corresponding pinion).

I'm not sure if you can just cut the frames a bit, without weakening them too much.

Maybe someone else has more input ...

Kind regards

Eddi

Born to fly ...
forced to work.

Hi,

the Pyro 800 wont fit cause of the 8mm shaft. You can mill it down by yourself to 6mm but thats not the best option.
Use the Scorpion and you will be fine

Kontronik is not planning to make a 6mm shaft for Pyros bigger than the 750.

Best regards,
Pascal

Hi Pascal,

XXtreme main gear, old pinions? Thought they were 8 mm ...

Will look weird, though, the considerably slimmer silhouette with the side plate-size main gear

Best,

Eddi

Born to fly ...
forced to work.

Hi Eddi,

this could work, yes. But as you said it maybe look a bit weird.

@spencerkey: If you want it simple - Use the Scorpion. If you want to use the Pyro: 8mm pinion and maingear would be the best.


Best regards,
Pascal

Thanks guys. I’m going to stick with the Scorpion motor. I dont want to mess with what works.

You will be fine, even If you want to run 12S!

Best regards,
Pascal

So is the Scorpion motor a 6mm shaft?

Edit; it is a 6mm shaft.



Edited 1 time(s). Last edit at 08/27/2020 05:28AM by spencerkey.