Hmmm ... indeed ... seem to be not working here ;-(
But - i have a idea with the MC's
- Set Throws to +-100 in setup
- Assign a channel Cell to the ESC output, lets say as Input Cell 20.
- In Cell 20 we use a MIX - Inputs are Cells 21,22,23 driven by Motor Switch (21 is off)
- Cell 21 is a Channel driven by FC ESC (which gives -100 at Motor off)
- Cell 22 is now the Idle Cell. Set up a useful 3-point curve, e.g. -100...-90...-80 and assign a poti you like
- Cell 23 (for flying) must be a Mixer of course- One Part is cell 22 (to keep the idle), the other is FC ESC
The benfit is now:
Instead of using a poti for "full range" - once you know your usual idle value you can shift the curve in Cell 22 so it is "usual in center" and could be altered by a defined margin you like depending on the steepness of your curve ;-)
Full Throttle Limit must be set in Cell 20 now with the highest trim and throttle of course.
regards (EN) / Gruss (DE)
Rainer Vetter
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.
Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
1 mal bearbeitet. Zuletzt am 06.12.2020 22:58 von RV.