Turbine Heli Soft Spool

Hello,

With a turbine heli, an initial soft-spool setting of 1 is needed to avoid ramping up fuel too quickly. The downside to this is that changing speeds while flying takes some time. Would it be possible to have a separate spool up setting from the bank switch speed change setting so that the two could be set separately? When I flew iKON, it had this and it was very nice with combustion helis since the spool up/clutch engagement could be slower.

Thanks!

No takers?

If you use the nitro governor - you can use the manual spoolup bank and just control by stick unless the HS is stable, then switch over to one of the other 2 governed banks.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.

I lose one bank at that point since it's used up just for spooling.