Vcontrol classic Gov setup

As a really old radio now, I'm finding it difficult to find information on specific menus for the classic VControl radio.

I'm setting up the nitro sensor, and in Governor->Gov Setup there is:

Sensor config (set up 2 for 1 magnet)
Gear Ratio (self explanatory)
Runup limit (3 default)

The last two options I am unclear of
Min throttle (30 default): What is this value declaring? I already have minimum and maximum endpoints set for open and closed throttle; and i set idle so that throttle cut switch closes the barrel all the way. What is the purpose of min throttle here?
RPM Range (default with my settings is 4800); but 9600 and 14400 values are also available. What does RPM Range manage?

Min Throttle is the throttle openening which will be the lowest one when Gov is active. More here:

https://www.vstabi.info/en/node/2030

RPM Range is a value to allow RPM >4800 1/min used on some smaller helis as a multiplier for the RPM in the VBAR Gov. Usually 4800 should be enough.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.

Thank you!!