Logo 550 SX V2: 16mm cyclic servo arms??

I am building a Logo 550 SX V2. The manual calls for 16mm cyclic servo arm holes. Where can I find servo arms with 16mm holes?

I use the Mikado Arms in the mid hole. It is 17.5mm as far as i know.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.

Just install at the point and orientation where the tail rod does have less friction here.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.

Hi,

and you might need to cut the tail servo arm, to make it fit.
The better hole there is the one were you get closer to around 100 limits, depending on the overall throw of the servo.
But also here, no need to be be perfectionist, you will have plenty of performance any way.

Kind regards

Eddi

Born to fly ...
forced to work.

For completion, I've been using 15mm servo arm holes on all 4 servos. I am using the Secraft 15mm aluminum arms. These are my numbers:

Neo 8° = "85"

+12° collective = "84"

- 12° collective = "94"

Rudder travel = 100 Left and 106 Right

Hi John,

sounds all good to me

Best,

Eddi

Born to fly ...
forced to work.