One way Logo 690SX on a Logo 600SX
June 19, 2019 02:18PM
Registered: 10 years ago
Posts: 155
Hi,
the one way on my Logo 600SX has broken and I realized there is a new one way bearing (MIK04876) that seems to be compatible with the L600SX.
I wonder if I can use that one way alone (changing also the main shaft) or it is necessary to change another piece in my Logo 600SX in order to be 100% compatible.
Re: One way Logo 690SX on a Logo 600SX
June 19, 2019 02:21PM
Moderator
Registered: 17 years ago
Posts: 17,802
Hello JC,
04876 is from the LOGO 600 / LOGO 690 SX and has a double one way.
You will have to switch to the corresponding counter bearing and rotor shaft support, too, because the double one way inserts directly into the latter.
Please compare the manuals of the LOGO 600 and your SX for details.
Re: One way Logo 690SX on a Logo 600SX
June 24, 2019 09:35AM
Registered: 10 years ago
Posts: 155
Hello,
this weekend I realized I have the carbon chasis on my Logo 600SX so I am not using the counter bearing and rotor shaft support include in the basic kit.
In that case should I use the Logo 690SX one way bearing or it is not compatible?
Re: One way Logo 690SX on a Logo 600SX
June 24, 2019 09:45AM
Moderator
Registered: 17 years ago
Posts: 17,802
Hi,
I'm afraid the carbon chassis is a thing of the past, originally made for the first generations of LOGO 500/600 but never updated, because of it not being widely used.
The double one way will not fit the third main shaft bearing support, and I doubt you can modify it so a corresponding bearing would fit, to take up the double one way.