TRex 600N with Mikado 04259 upgrade for Align Metal grips

Would you please check my parameters because I had to change quite a few servo reversing etc.
I use a standard 600N Pro with the Mikado head conversion for the Align aluminum grips as per instructions (leading).

My configuration is as follows:

Tx JR 12X DSM
Rev servos: Throttle, Aileron, Rudder

Rx Spektrum 9000
Scott Gray Reactor-X regulator
Fromeco LiIon 2600 mamp battery
Multigov Pro for throttle and mixer control

Cyclic servos JR 8717 (x3)
Tail servo Futaba 9556

VStabi gyro is placed in-front of the main shaft above the 2 cycle servos with the wire pointing forward.

Today I had 4 amazing flights without any issues. I started with simple hovers, then slow circles, and after a couple of refills I tried tic-tocs, loops, roles, some really FFF even auto-rotations without any hiccups. I still have not run the auto-trim procedure been little windy lately. The 600N with the VStabi flies like it is on rails! I am amazed with the precision it loops, rolls and keep pirouetting even during FF flight.

After today's multiple flights the parameters should be good or could be any future surprises?



Edited 2 time(s). Last edit at 07/20/2009 03:48AM by HeliNick.