Would you please check my parameters because I had to change quite a few servo reversing etc.
I use a standard 600N Pro with the Mikado head conversion for the Align aluminum grips as per instructions (leading).
My configuration is as follows:
Tx JR 12X DSM
Rev servos: Throttle, Aileron, Rudder
Rx Spektrum 9000
Scott Gray Reactor-X regulator
Fromeco LiIon 2600 mamp battery
Multigov Pro for throttle and mixer control
Cyclic servos JR 8717 (x3)
Tail servo Futaba 9556
VStabi gyro is placed in-front of the main shaft above the 2 cycle servos with the wire pointing forward.
Today I had 4 amazing flights without any issues. I started with simple hovers, then slow circles, and after a couple of refills I tried tic-tocs, loops, roles, some really FFF even auto-rotations without any hiccups. I still have not run the auto-trim procedure been little windy lately. The 600N with the VStabi flies like it is on rails! I am amazed with the precision it loops, rolls and keep pirouetting even during FF flight.
After today's multiple flights the parameters should be good or could be any future surprises?
Edited 2 time(s). Last edit at 07/20/2009 03:48AM by HeliNick.
Attachments:
open |
download -
TRex-600N-07-17-09.vbr
(5.5 KB)