Hi All,
Just thought I would share some pictures and build info about my new Logo 700!
Setup is as follows:
Kit: Logo 700 (Stock kit)
Motor: Scorpion 4525-520kv w/ 6x55mm Shaft
Pinion: 14T
ESC: Scorpion 160HV Commander Opto (Will switch to Tribunus once released)
Servos: Xpert R1's for Cyclic, Xpert R1T for Tail
FBL Unit: V-Bar NEO w/ Pro Software
Batteries: Thunder Power 12S 5000mAh 70C Stick Pack
RX Pack: Thunder Power 2S 1350mAh
Connectors: RCProPlus S6 for main batteries, RCProPlus D4 for rx pack
Blades: VTX 717, Edge 105SE Tail Blades
For flying parameters:
Collective Pitch: +13
o/-12.5
o
Cyclic Pitch: 8.3
o
Agility: ~108
Gain: ~67
Tail Gain: ~70
As far as the optimizers and expert values, they are almost stock. I have not adjusted them much.
RPMs: 1400-1800-2160
Build/Setup Tips:
For me, I decided to hard mount all my servos, with doing this, all the servos need to be properly spaced forward to get the geometry correct again. I used the plastic servo spacers that Mikado used to sell with the 500/600 kits. They provied the correct spacing and make installation very simple.
In regards to the head damping i have chosen the existing setup from the old 700 XXTreme: 80-80-90. The 90 durometer damper is on the outside.
One other thing I came across was the tail pushrod seemed a bit on the long side. I would suggest trimming it down 5mm before you glue the ends on. I had to move my servo horn one spline to compensate for the length.
Overall, it is a very very smooth build. From opening the box to being ready to fly, it took me about 7 hours. If anyone has any questions, please feel free to ask!
Thanks, Jesse