start && end > -1) { if (start > -1) { var res = data.substring(start, end); start = res.indexOf('>') + 1; res = res.substring(start); if (res.length != 0) { eval(res); } } cursor = end + 1; } } } //]]>
thanks.. if I understand this correctly. motor control is switch and not via stick.von silas - VBar NEO (non VLink)
attached, thanks. The problem appears that the servo doesn't move on first half of the throttle stick when connected to the NEO.von silas - VBar NEO (non VLink)
in operation mode. and channel for throttle is ch 3. S-bus in a futaba RX. all the other channel works fine. If I plug is servo to ch 3 (throttle) to the rx directly, the servo works as it should. If I go thru the NEO, this is where the problem is.von silas - VBar NEO (non VLink)
trying to set up a NEO, for some reason, it doesn't pass throttle channel information to ESC correctly. Replace to the ESC with a servo to see what is going on. You can see as the stick advance, the servo doesn't operated correctly. See link to the video https://youtu.be/1BDu_GAtAj8 Is there a setting I missed in the setup or the NEO is bad. I am using external gov and at the gov setup, ivon silas - VBar NEO (non VLink)
Does anyone has an idea on how to set the cyclic servos in the NEO to support 760us? thanksvon silas - VBar NEO (non VLink)
I am installing the Neo in a scale body, I read somewhere that for scale body, it needs an external sensor. Can I use the internal only for scale body? If the internal sensor is more precise, will there be a more precise external sensor available? thanksvon silas - VBar NEO (non VLink)
Can I increase the length of the external sensor wire? if yes, what is the maximum I can have? thanksvon silas - VBar NEO (non VLink)