start && end > -1) { if (start > -1) { var res = data.substring(start, end); start = res.indexOf('>') + 1; res = res.substring(start); if (res.length != 0) { eval(res); } } cursor = end + 1; } } } //]]>
Any ideas on where I can borrow the power from to power some LEDsby stevin - Café
thats great but anyone know of a howto? where to borrow power from to run the LEDs.by stevin - Café
so at the moment this upgrade cant even be done?by stevin - Logo 200/400/500/600 Questions
yes for the logo 600, I believe the new part I am referring to was revealed at rotor live.by stevin - Logo 200/400/500/600 Questions
I seen some videos in the past of people installing a light kit or something to make the V light up as well as other parts of the radio. Does anyone know if there is a kit available or a how to posted online? I would like to experiment with adding lighting to my VBC.by stevin - Café
what is needed to upgrade to this new part?by stevin - Logo 200/400/500/600 Questions
I crashed my trex 600l dominator and after repair I have a large forward drift. In the swash trim section of setup, the swash plate is perfectly level and has 0 degrees, collective endpoint trims has the swash level as well. I attempted a trim flight and the nose drift continues even in the trim flight. This can be seen on the bench, after an input the swash eventually ends up tilting forward hanby stevin - Café
I am trying every way possible with no luck. I plug in boot plug and USB then power up and I get a faster flashing white light. If I plug in without the boot plug it starts with a blue flash and the. Goes to green -red. Either way the Vbar control manager does not recogniz it. When I look in my device manager I find it under USB as virtual flybarless controller , updating driver does nothinby stevin - Café
So this is on my oxy2 that I had to trick the system by cutting the poles in half and asking for half the desired head speed. I hear no change in rpm when switching from different flight modes. The logs are completely filled with gov full throttle messages. What should I check?by stevin - Café
So I have my Neo setup on the oxy 2 using the vbar governor with VBC. The heli is flying great and the tail holds strong on high speed funnels however I do notice feeding in alot more rudder then I feel I should in backwards flight such as high speed hurricanes. Also when doing pirouetting maneuvers and feeding collective I notice the tail doesn't want to stop when I stop feeding rudder. Nowby stevin - Café
TY rainer, after recovery firmware was loaded I noticed the light on the mini vbar stopped coming on. Is this normal?by stevin - Questions V5
So the vbar im referring to is a mini vbar that I was using my my vcontrol. I sold it to someone and he requested that I put the 5.3 pro back on it. I used the recovery firmware and removed 6.0, so now it connects with the USB to my computer using the 5.3 software but when I click on top under file/online update I see 6.0, 5.3 express, and 5.3 pro however non of them have a check next to themby stevin - Questions V5
Ah yes double it, not half the pole. Do you think this is something well see updated in the VBC software? It would be nice to have a true RPM read out. Doesn't seam like it should be that hard to accomplish.by stevin - Café
I just set up my new oxy 2 this weekend using the neo and my VBC, I soldered on a Hw rpm sensor and attempted setting up the Vbar governor, however once the rpm number hits 4800 in the VBC it stops! Is this the limit? If so it would be nice to address this maybe in an update. Others have suggested tricking the system by cutting the poles in half and asking for half the head speed desired. Wouby stevin - Café