start && end > -1) { if (start > -1) { var res = data.substring(start, end); start = res.indexOf('>') + 1; res = res.substring(start); if (res.length != 0) { eval(res); } } cursor = end + 1; } } } //]]>
Got everything registered and rescue installed but no power for channels 1-4. I have a vcontrol non touch and have verified the servos work. There is power to the tail servo and aux ports but nothing for the cyclic servos. Just to clarify, servos are plugged in correct and they work when plugged into the aux port. Vcontrol and neo freshly updated and started with a new model. I do have anotby jgalen0025 - VBar VLink
I have to admit, I have had a horrible experience with building the head on this heli. With having built around 20 helis including an older logo 600, I dont remember ever having this much trouble with installing dampeners, feathering shafts and blade grips. I finally got the orings into the head block without them popping back out and the feathering shaft is on (per the manual). Feathering shaftby jgalen0025 - Logo 200/400/500/600 Questions
I need help with reassigning the throttle servo output to Channel 4 as it is currently only working on the usb side servo port. Setup is in the subject. I guess I need to use Macrocells but dont have the slightest clue how to achieve this? The throttle servo is HV so I need to run it off the main powerbus (channel 4). Not sure if my thinking is correct on this one? I just want to provide myby jgalen0025 - Café
I was in the process of updating a silverline from 5.3.4 to 6.xx and it stopped working and lost connection. I downloaded the recovery file, followed the instructions and just when the bootloader starts it gives me a message that "the software was not loaded correctly. The unit is not operational." I have tried resetting everything including the power, software, and anything else thby jgalen0025 - Questions V5