start && end > -1) { if (start > -1) { var res = data.substring(start, end); start = res.indexOf('>') + 1; res = res.substring(start); if (res.length != 0) { eval(res); } } cursor = end + 1; } } } //]]>
Eddi, I have sent an email about the spacer that I need. I think the issue I have is that I can only find spare parts that fit a 10mm spindle. The part that I was sent which is listed for the XXtreme 700/800 and the 700 non xxtreme (04702) is for a 10mm spindle (20mm thrust bearings outside dia). The head that I have is a 12 mm spindle and 23mm thrust bearings. Has the head been updated?by Sharpedge - Logo 700/800 Questions
Eddi, Rainer, Thank you for the information. I have ordered the 700 thrust bearing set so hopefully the spacer is in there. I have a VBAR blueline with external sensor that I am going to use on the 800. I recall that a special firmware was available for the blueline/silverline for use with the 800. Is this still needed/available? I have 5.3.4 Pro installed.by Sharpedge - Logo 700/800 Questions
The 700 and 800 Xxtreme use the same rotor head thrust bearings. From the manual I see that the only difference is the extra washer that is used in the 800. Part 4502 in the 800 manual shows the thrust bearing and the washer. All the online stores only list 4502 in the 700 section. Does this part also include the washer? I bent one and need to replace the washer, is it sold separately?by Sharpedge - Logo 700/800 Questions
I picked up a second hand log 800 that did not come with the machined screws to fit the servos. Do all the servo screws come with the Screw Set Chassis, LOGO XXtreme . I also do not have any servo arms for the heli, is there a part number of the supplied servo arms? Thanksby Sharpedge - Logo XXtreme 700/800 Questions