start && end > -1) { if (start > -1) { var res = data.substring(start, end); start = res.indexOf('>') + 1; res = res.substring(start); if (res.length != 0) { eval(res); } } cursor = end + 1; } } } //]]>
Thanks eddie tried this and still the lines are there. I have opened a service request. Again thank you. Shane.by cowboyjester - Questions VBar Control Touch
Hi i bought a vcontrol touch on the 26th june and when turned on tonight two blue lines apeared on the screen the lines are vertical,, Any ideas i have tried to upload a photo but the photos are too large a file.by cowboyjester - Questions VBar Control Touch
Hi eddi. I would be happy to return the part to you. I have already changed out the part so no need to send me another as i always buy 2 when replacing parts then i have a spare. Thank you for the offer, but reiners help was invaluable and i am very grateful for his help. That was priceless for me and this only shows what a great investment it was going for mikado helicopters and miby cowboyjester - Logo 200/400/500/600 Questions
Hi rainer. Firstly sorry again for using the forum wrongly. Secondly thank you for your insight into my heli as without your help i would not have found the problem. The problem was with part number 04630. The area where the thrust bearings sit, one side the shaft measures 4mm at both the screw end and also at the other end. But on the other side it measures 4.5mm at the screw end whby cowboyjester - Logo 200/400/500/600 Questions
Thanks reiner, I went to check the thrust bearings as you suggested one blade grip came off easily, However the other side was stuck when i got it off the outer thrust washer was tight to fit the shaft. The shaft looks bell shaped and the outer thrust washer will not fit. It is wider at the screw end, the other side looks fine. Could this be the problem do you think?. I am goingby cowboyjester - Logo 200/400/500/600 Questions
My apolagies reiner i am new to this forum in fact any forum. Sorry if i have caused offence. I am using a vbar neo with vbar control, Tail servo is futaba bls 251 cyclic servo,s futaba bls451 motor scorpion hk3 425 1100kv esc is kontronik jive. Standard maingear with 14t pinion. The wag is about 8 to 10 cm both ways from center and slows with less gain and speeds up with more. I have checked theby cowboyjester - Logo 200/400/500/600 Questions
Please i have tried everything i can after years of heli flying. I have a constant tail wag, tail is silky smooth i have tried different servo's futaba savox align. I am using kontronic esc and vbar control on a neo the wag is similar to a hunting scenario but just speeds up when gain increased and slows when decreased. As i said tail standard and free from glitches. Esc programmed through vbar cby cowboyjester - Logo 200/400/500/600 Questions
I have a constant tail wag on my 550sxi have changed servo's no change tail is silky smooth i am using external gov on vbar control with a kontronic esc. I have seriously tried everything suggested on forums and no change. Programmed esc through vbar control several times and selected 4 beeps. Please help been trying to sort it for 4 weeks.by cowboyjester - Logo 200/400/500/600 Questions