start && end > -1) { if (start > -1) { var res = data.substring(start, end); start = res.indexOf('>') + 1; res = res.substring(start); if (res.length != 0) { eval(res); } } cursor = end + 1; } } } //]]>
Hello, I am getting the following attached response when trying to upgrade to Pro. Any ideas? Thanksby Nigel - Questions V5
Anybody found an alternate spherical bearing that fits? my swash is far too tight below 10Cby Nigel - Logo 700/800 Questions
The Swashplate ball is very tight on my machine, I fear it is going to ruin the servos, I have removed the ball and I am thinking of using an abrasive paste to loosen it up? Any advice? Thanks Nigelby Nigel - Logo 700/800 Questions
I attempted to apply the latest update for the VBar Control using my Laptop (I have used it to update before, windows 10). For some reason it will not connect properly to the VBar control, you can see a drive, but clicking on the USB drive results in 'insert drive'. The same Laptop did however allow me to update all my Neos. The VBar control is in 'stick ' usb mode. In order to update my VBarby Nigel - Café
Hello, Has anyone fitted the V2 frames in the Uvular fuselage? Are the mounts in the same place? Thanks Nigelby Nigel - Logo 200/400/500/600 Questions
It was the Heim ball to the delrin housing. The swashplate has now been replaced by the supplier.by Nigel - Logo 200/400/500/600 Questions
I have just started building my new 550SE, the swashplate ball is far too tight and the servos will be barely able to move it (even at room temperature). Is there a fix for this?(using an abrasive paste to increase the clearance?) Thanks Nigelby Nigel - Logo 200/400/500/600 Questions
Thanks, I will get 4622 the counter bearing, then the new mainshaft 4772 (211mm) when it becomes available as a spare. Nigelby Nigel - Logo 200/400/500/600 Questions
Hello I want to upgrade my Logo 600SE to the latest spec , I already have the main rotor hub MIK4631. I want to add the new counter bearing support. So are the parts (mainshaft and counter bearing support) in MIK4623 the same as in MIK4764 apart from the main rotor hub. Thanks Nigelby Nigel - Logo 200/400/500/600 Questions
Hello, I have just changed a Standard VBar for The Mini-VBar in my Logo 400. The standard VBar worked well. I am having a problem with getting the Mini VBar to trim correctly. When in trim mode the model wants to slowly roll to the right. The trim indicator ends up showing a full green bar. I have tried a completely new setup from scratch several times with the pre-set and get the same resuby Nigel - Questions V4