VBar Governor Issue

I fly F3C and have run into an issue setting up the governor where, if I use a curve that does not have zero pitch at mid-stick (we hover at mid-stick) the VBar governor is very unstable. It's almost as though the governor is expecting zero pitch at mid-stick for the calculations it makes, rather than reading zero pitch from the pitch curve. Is there a way around this?

It's affecting my nitro model and it affected a friend with a Scorpion ESC this weekend. He had to switch to using the Scorpion governor to be able to fly in a competition.

Did you teach the system where zero collective is?

In VBCt - it is im Setup, Swash Expert.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.



2 mal bearbeitet. Zuletzt am 25.10.2021 05:25 von RV.

Will that affect all the banks? So if I have a bank that has zero collective at mid-stick, will that change? Thanks!

Nope - it does not. The servo plusewidth is always the same for zero even if changing curves. Otherwise you have to change rod lenghts "In flight" too ;-)

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.

Ok, I will try that and see how it goes. Thank you!