RPM Glow Sensor

Hi guys!
Please can i have some help for Glow Engine?
It’ s my first exprerience with a nitro heli (i’ m fly only Electric).
I need a RPM sensor for my vbar neo but i dont found a mikado sensor

Where i can buy them?
Thank you

Adrenalyn

Goblin Kraken/Xnova Tareq 550kv/Hobbywing 200ESC/MKS Servo’s
Goblin Kraken/Xnova Tareq 550kv/Hobbywing 200ESC/Kst
Servo‘s
Goblin Kraken Nitro/O.S. 105 HRZ/MRCI Muffler/MKS Servo’s

Mikado Vbar Control Touch/Vbar Neo Pro

Hi,

you can use any magnet or back plate sensor, you should find it as accessories where you buy your engine(s).

Afaik Kyle Dahl himself uses the Spektrum backplate sensor, without issues.

Kind regards

Eddi

Born to fly ...
forced to work.

Sorry Eddy i’ m read only now your post.

Thank you for your support.

I’ m have one Futaba-SBS sensor back plate. I can connect this in the rpm port without swap red and black wire? 7,4 voltage right?

Thank you very much Eddy!

Adrenalyn

Goblin Kraken/Xnova Tareq 550kv/Hobbywing 200ESC/MKS Servo’s
Goblin Kraken/Xnova Tareq 550kv/Hobbywing 200ESC/Kst
Servo‘s
Goblin Kraken Nitro/O.S. 105 HRZ/MRCI Muffler/MKS Servo’s

Mikado Vbar Control Touch/Vbar Neo Pro

Hi,

to the best of my knowledge, you only have to swap wires on the Align sensor, because it has a different/non typical polarity to begin with.

Otherwise, it's always –|+|~ and there would be no need to swap any wires.

Kind regards

Eddi

Born to fly ...
forced to work.

thank you Eddy

Adrenalyn

Goblin Kraken/Xnova Tareq 550kv/Hobbywing 200ESC/MKS Servo’s
Goblin Kraken/Xnova Tareq 550kv/Hobbywing 200ESC/Kst
Servo‘s
Goblin Kraken Nitro/O.S. 105 HRZ/MRCI Muffler/MKS Servo’s

Mikado Vbar Control Touch/Vbar Neo Pro