Vertical and Horizontal Frame Plates Loose

After several gallons through my new Glogo, I noticed that the front vertical CF plate and the rear horizontal CF plate above the tank are loose. Both of these are located with four tabs into the main frames and they can be slid back and forth, enough to rattle.

What would be a good solution to prevent further wear? I hesitate to use epoxy or any type of adhesive. Any suggestions?

Thank you,
Bob

Hi Bob,

this is a thing I've seen on a couple of cf frame designs, from the venerable LOGO 14 through to the XXtremes.
Fix those with a drop of CA, epoxy or hot glue, job done.

Kind regards

Eddi

Born to fly ...
forced to work.

Will do. Thank you.