Vertical and Horizontal Frame Plates Loose
August 22, 2019 05:34AM
Registered: 4 years ago
Posts: 22
After several gallons through my new Glogo, I noticed that the front vertical CF plate and the rear horizontal CF plate above the tank are loose. Both of these are located with four tabs into the main frames and they can be slid back and forth, enough to rattle.
What would be a good solution to prevent further wear? I hesitate to use epoxy or any type of adhesive. Any suggestions?
Re: Vertical and Horizontal Frame Plates Loose
August 22, 2019 08:52AM
Registered: 17 years ago
Posts: 17,798
Hi Bob,
this is a thing I've seen on a couple of cf frame designs, from the venerable LOGO 14 through to the XXtremes.
Fix those with a drop of CA, epoxy or hot glue, job done.