My default switches don’t talk anymore!!

When I used to flip the motor to on, it would say motor on, motor idle, and motor off. It would also say bank 1, bank 2 and bank 3. (All by default I think) now it says nothing. I did set up a switch to say “normal mode” and stability mode” that switch still talks like it should. Motor hold and banks switch say nothing.
Everything used to work I’ve changed nothing that I know of. Any helpful would be greatly appreciated.
Volume is at 100%
I’m running V8 firmware.
I have Susan active, talking telemetry active, talking switches and talking switches pro all active.

HELP!


Thank you.

Hi,

please disable the regular talking switches as you have Pro enabled.
Only one at a time.
Then, either set up the default switches manually, too (it's Pro after all, so everything is user-defined), _or_ start with selecting one of the Presets at the bottom of the list.

Best,

Eddi

Born to fly ...
forced to work.

So FYI for anyone that may experience this I figured it out. I pretty much had to uninstall anything talking, audio related and then I reinstalled it and I made sure the default talking was on and then I set it up on switches, etc. how I liked.