Glogo 690 is gone and nitro gov app changed.

Hi,
I just come back to my Glogo 690 after 1 year,
Bind to new VBC,
I do not see the Throttle Cut in Nitro
Gov setup.
It worked fine before and I did
not change anything in Vbar.
Try another Vbar with new setup and I do not see Glogo list in Mikado heli presets menu, only electric.
Throtle Cut switch also disappear.
Please advise, vbar control touch and neo have latest update.
Thank you.

Found that Throttle Cut switch is set
in Output, but was reset to Buddy.

Hi,

I guess it was the other way around, the physical switch was assigned to Buddy, and Buddy was assigned to act as Throttle Cut.

That's the way it'd designed, assign physical switches to functions (Motor, Bank, Buddy, Opt 1-3), then assign functions (unused physical switches) to tasks, whatever you want them to actuate.
Buddy doubles as Opt 4, since not everyone is buddy boxing, or when-not buddy boxing, it can of course be used for functions like Rescue or Throttle Cut, or you can even created sensible doubles, like Buddy/—|Master/—|Master/Rescue.

Another thing to mind is, if you—for whatever reason—re-install your transmitter, it is mandatory to re-do the transmitter setup, including switch assignments, and check and assign tasks like Rescue or Throttle Cut again.

Kind regards

Eddi

Born to fly ...
forced to work.

Thank Eddi,
I ussually set Rescue is lower right memotary switch, and upper is Motor switch. Bank is upper-left, opppsite with Motor.
SW Option 1, 2 is two top switchs for all my VBC.
That's strange is the macrocell for switch glow works as my previous setup with sw option 1,
That's explain why I was able to start the engine with switchglow but then recognized that no switch to turn engine off, I have to reduce the idle to 0.
The sw option 2 was set for throttle cut did not work at the time, surely it was not set to Buddy because Vneo has rescue that take Buddy already.
I checked again in Output it set to buddy, that maybe I clicked on Vbar nitro gov so it reset to default.
The next thing Glogo is removed from Preset list, I can select other and setup Nitro governor but prefer Glogo display in model screen.

Hi,

hm, strange. There is no explicable way why settings should change on their own, both on the transmitter or on a VBar.
My best guess would be, something was changed during the noGLOGO year, but of course I don't want to imply, I can not tell.

GLOGO preset, I must confirm. No idea where it went ...
But you are still be able to select and remove the default image from your screen, and add a Mikado image, then select the GLOGO from the list.

Kind regards

Eddi

Born to fly ...
forced to work.

Thank Eddi,
All works fine with more "click" than before.
One more thing I see that when I click on Vbar N governor(wanted or accidental) it reset the servo end point to -100/100, if mechanic is not good such as -90/90, cause the servo binding, it is better to set -40/40 like setting tail servo.

Hej,

good idea, I guess Rainer will pick this up eventually.

Kind regards

Eddi

Born to fly ...
forced to work.