EF turbo bushmaster full span ailerons help

how would I go about setting up full span ailerons with macrocells?
Ive never really used them and its a bit confusing

I don't know any plane and don't know which VBC to set up - but i guess you have ailerons configured and flaps configured with the wingmixer already.

So - in the wingmixer expert (long press on vbct on the regarding flap output) just add the amount of aileron you want.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.

Hi,

most important thing to me is, start with a new setup (if you have already done so, good!), and adjust regular control surfaces only via setup, don't 'mess' with Macrocells until you eventually need to.

Then, as Rainer stated, you can enter mix components to each servo output (mind short-tap and long-tap give different menus), so you could mix flap with aileron (full span aileron) or aileron with flap (full span flap, or crow), and also elevator with flap to trim when changing the wing's geometry, it's all there.

Use Macrocells only for features which can absolutely not be set up in setup.

Best,

Eddi

Born to fly ...
forced to work.

Thank you guys, I am going to try and get the set up done tomorrow and will update with my findings!