Hi,
Pro-tip: during the setup in a classic VBar Control, you see the channel assignments. On a Touch, you have the wing mixer with the same info.
If you connect as you go through the setup, you can't go wrong.
Pro-pro-tip: it's similar to a heli setup: ESC=ESC, RD=Tail (some logic in it
), CH1=Elevator (usually the 'elevator' servo, in a 3-point-swash plate), CH2 and CH3=Ailerons (again, same as on a LOGO swash plate, CH2 left, CH3 right, you count from the 'elevator' servo, clockwise—again, some logic in it
).
For those who read manuals, there's a table with the connections in it, too.
Kind regards
Eddi
Born to fly ...
forced to work.
1 mal bearbeitet. Zuletzt am 19.06.2020 15:10 von Eddi E. aus G..