micro heli receiver and telemetry OMP

I just got an OMP M2V3 helicopter and installed the new micro heli receiver to use with my VBAR Control Evo. The SBUS connects fine and the heli controls work. However, the button to enable "VBar Control Telemetry" in the OMP app will not work. I updated my transmitter before installing this receiver. I have power cycled several times and deleted and reinstalled the app. Still the button for telemetry in the app will not work, it just goes back. No problem with the "S BUS range" which I set to Futaba, the button right above the telemetry button, which worked without problems. Is there something I need to check in macrocells? Did I perhaps get a flawed OMP control unit? Thank you.


I updated the firmware and it works now!



Edited 1 time(s). Last edit at 06/23/2026 11:38PM by Drav8r.

To enable Vbar telemetry you have to update your OFS3 firmware to min. version 15.20.

As I see you figured it out by yourself already.