Used Logo 200 UI sensor

Hi,

I have purchased used Logo 200 UI sensor, but previous owner has been modified sensor - remove one XT30 connector and added some wires. Is it right that after any modification sensor must be calibrated? If i will repare sensor as original is will be close to correct consumption calculation?

There is no need for calibration when changing the wires. The calibration is in between the shunt and controller.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.

RV Wrote:
-------------------------------------------------------
> There is no need for calibration when changing the
> wires. The calibration is in between the shunt and
> controller.


Thanks RV!