Vbar control connects then disconnects

Had a situation this morning where the Neo initialised, the vbc touch confirms connected, then disconnected on the bench (sticks still operated the servos), after a short while, it connected again.

Any ideas why this would happen?

I restarted everything vbc touch, neo. Tx on, powdered up scorpion esc. Same again. After a couple of times it was ok.

Using vbc touch, neo, tribunus Ii 200A. All connections are fine.

The VBC was too close to the model and in perfect orientation, so the telemtry from model to VBC (this is the connect control) was far too "loud" on the vBC antenna.

Just turn the VBC a bit or move it 10 cm away ;-)

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.

ah, yes, that may well be it. thanks