start && end > -1) { if (start > -1) { var res = data.substring(start, end); start = res.indexOf('>') + 1; res = res.substring(start); if (res.length != 0) { eval(res); } } cursor = end + 1; } } } //]]>
Re: Vbar control touch won’t governor on tribunus 200 esc! May 06, 2020 06:29PM |
Registered: 3 years ago Posts: 16 |
Re: Vbar control touch won’t governor on tribunus 200 esc! May 06, 2020 07:31PM |
Moderator Registered: 17 years ago Posts: 40,785 |
Quote:ich habe die gleichen Probleme.
Das Kabel habe ich schon getauscht und mit Multimeter durchgemessen.
Wenn ich das Kabel am Neo abziehe habe ich auf meiner touch control kein Scorpion Icon mehr und Drehzahl steht auf 0.
Ebenfalls kommt die Fehlermeldung Low RPM:0 RPM
Sobald ich es stecke ist es wieder da und die Drehzahl wird wieder angezeigt.
Auch kann ich im Drehzahlregler die Drehzahl nicht verstellen, nur über Basisgas kann ich die Grunddrehzahl verändern.
Die Drehzahl wir immer auf die Basisgas Prozente gestellt.
Quote:Please do this:
- run the heli
- read the rpm (comes from telemetry)
- disconnect telemtry cable
- rpm will come now from RPM input (used for Gov!)
When the RPM is gone now - the "RPM" cable for the NEO isn't plugged in or wrong ...
Re: Vbar control touch won’t governor on tribunus 200 esc! May 06, 2020 07:38PM |
Moderator Registered: 17 years ago Posts: 40,785 |
Re: Vbar control touch won’t governor on tribunus 200 esc! May 06, 2020 09:32PM |
Moderator Registered: 17 years ago Posts: 40,785 |
Re: Vbar control touch won’t governor on tribunus 200 esc! May 07, 2020 01:19PM |
Registered: 7 years ago Posts: 201 |
Re: Vbar control touch won’t governor on tribunus 200 esc! May 07, 2020 10:06PM |
Registered: 15 years ago Posts: 303 |
Re: Vbar control touch won’t governor on tribunus 200 esc! May 17, 2020 05:18PM |
Registered: 3 years ago Posts: 16 |