Kolibri 60LV with NeoExpress + VLink Sat : No telemetry

Hello everybody,

Hope you can help me with a strange problem I have with my Kolibri 60LV : I cannot receive the telemetry info on my VBC.

My setup is like this:
-NeoExpress + RX Sat
-Kolibri 60LV setup with Mikado in TELE1 (selected with ProgUnit)
-Tele cable plugged into the TELE port (white wire in the middle of the port with 5pin + black on the black side, I would say the center of the ESC)
-tele cable plugged into the AUX1 port of my NEO

But nothing is displayed, when I plug the lipo I receive nothing, and I do not have the battery selection menu.

To be honest I do not even know if my cable is fine.

Can someone help me?

Do you have the Kontronik App installed?
Stephan

Yes, the kontronik app is added to my VBC.

I have a Ksomik with a telme it works correctly, but not with the Kolibri 60LV :-(

Check the protocol output from the Kolibri again.

I've checked several times, still not working.

What does the sentences "Caution: Telemetry only possible once per controller" in the comment area in K Konfig?

I've bought the ESC to someone else and he was using another protocol (Graupner I think)

I attach a screenshot of my K Konfig parameters

Activate the side port with mikado protocol
Use the side port and try again.

Not sure i can check my kolibri 140 later next day

there is a difference between Kolibri 140LV...

There is no side port on the kolibri 60LV, the manual says the side port is only for kolibri 140

do you have a kolibri 60 ?

Now it works...

Hi,

what did it for you, if you know? A known issue could be that the ESC is connected to TELE1, which is also good for our (analog) telemetry sensor.
Upon power up, the VBar tries to detect telemetry. If the ESC does not/yet output a valid signal, it could revert to temperature, taking the ambiguous signal for what it isn't.

This is only known for K ESCs, by the way.

Cheers

Eddi

Born to fly ...
forced to work.