MKS HBL950 Servo Fit/logo 700 XXtreme

Am putting together a logo 700 using MKS HBL 950 cyclic servos. These are a bit too long and don't line up with the stock drilled mounting holes. I can get round this by making small spacers for the front two cyclic servos but how do I get round the problem for the back cyclic servo?

Thanks in advance

Dan

Hi Dan,

As per my PM, I just elongated the bottom set of holes so the screws could go into the mount.

Hope this helps,

Mark

Cheers Mark

And thanks for the quick response.