New logo 550 build Tail case bearings and glue.

The bearings in the tail fin and tail case says to glue the two outer ones in. Mine are in very tight from mikado and I’m not sure whether to bother gluing them in as they are not coming out/rotating easily?
Also do I need to glue the drive belt bearing in the tail case it’s a bit unclear.
Thoughts.

Hi,

if the bearing sit tightly, I do not glue them either. With the painted fins, they usually hold fine just so.

Otherwise, I only loctite metal bolted joints, that's it.

Of course you can also glue bearings to shafts, bearings to bearing seats, but that makes maintenance a pain later.
I found the less you do, the less you do wrong, and the less issues you have in the long run and I speak of 400-600 flights at best, between human brain failures leading to the inevitable

Kind regards

Eddi

Born to fly ...
forced to work.

Thanks For your reply, very helpful.