550 SX align servos

Hi,

I’m building a Logo 550sx v2. I have followed the manual and fitted the ball links as instructed.
Im using align DS620 servos and it looks like the control rods are at a slight angle. The servo arms looks as if I need to remove the nuts that are behind the ball end.

Is this right?

Hello,

a slight angle is usually not a problem. I would leave the nut installed, or at least use a washer instead: the edge of the ball can else cut into the plastic and cause play, while the flat surfaces (ball-flat nut-plastic-flat nut) do not cut the plastic and provide better hold.

Kind regards

Eddi

Born to fly ...
forced to work.

Many thanks

One other thing. How many teeth do the standard Mod 1 gear have ?

106