Logo 550 2017 - Servo Mounts
January 16, 2018 02:34AM
Registered: 7 years ago
Posts: 6
I'm about to start my first Logo 550 build and was curious if anyone has had issues securing the servos using the provided self-tapping screws to the plastic frame? It doesn't look very secure..
Is there anything I should be aware of when mounting the servos? Or anything else for that matter!
Thanks in advance for your assistance.
Edited 1 time(s). Last edit at 01/16/2018 02:34AM by Brianmurray77.
Re: Logo 550 2017 - Servo Mounts
January 16, 2018 08:29PM
Registered: 12 years ago
Posts: 340
Hello,
I guess you mean the three swashplate servo screws right?
You should not tighten them too much.There are no issues with this kind of mounting the servos to the mainframe.
You do not need loctite as well because they are cutting their own thread during tightening them and also because loctite is useless on plastic materials.