Setup Procedure for Turbine FADEC Vtouch with NEO Pro

Hello,

I was wanting to find out if there is anyone who has the procedure in setting up a Turbine FADEC system on the Vtouch system?

I have looked thru Vstabi but had no luck. I just wanted to see if it can be done and if so what microcell is used if need or if anyone has any idea's.

Thanks,

Tim

Hi
Rainer gave me this answer in attached file here on the forum. It is actually very simple and only makes use of the MOTOR switch.

VControl, VBar on all.
TDR, TDR2, TDF, TDS and TDSF
Peter

Hello,

Thank you for the document. I will give it a try. The turbine I will be using is the King Tech t-45H G4 helicopter. I do have one question? Does this procedure work for the helicopter or is this for fixed wing.

Thank you

Tim

For any turbine as they all have similar start procedures.

VControl, VBar on all.
TDR, TDR2, TDF, TDS and TDSF
Peter

Thank you very Much!!

Tim