HobbyWing Platinum PRO V4 130A HV ESC (6s-14s) has 10A built in BEC (need programming box also)
-Update to latest firmware to get rid of tail kick issue.
-Disable low voltage cutout and use Vbar UI sensor with battery logging
-Choose Fixed Wing for governor type
-Set end points with Vbar setup software by
turning on throttle servo adjustment (temporarily), powering up full throttle and after beeps lower throttle to zero. Go back into Vbar NEO software for gov setup and
turn off throttle servo adjustment.
RPM setup Bank 1 2300, Bank 2 2400, Bank 3 2500 to start... needs 22 or 23 tooth pinion
Castle 160 is cheaper but you will need an external BEC and it is only rated for (6s-12s) not 14s if you go there.
Edited 1 time(s). Last edit at 07/05/2016 10:46PM by weracemo.