Hello everyone got a issue that I seen on the bench when finishing off setup and never seen this before. My setup is Vbar Control and MKS servos. When i put the stick to 0 pitch, and move the cyclic stick off of center right or left I see a pause half way in the cyclic travel and it happens on both cyclics and at any pitch. The way i would describe it is the servos stops briefly then moves. I tried to see if it would happen when I use other servos Futaba and the same thing happens.
Took a vid hope link works.
https://www.youtube.com/watch?v=T_FRAK64voc
Thanks for your time.
Kevin.
Edited 1 time(s). Last edit at 06/14/2015 08:51PM by Rappy112.