I just got an OMP M2V3 helicopter and installed the new micro heli receiver to use with my VBAR Control Evo. The SBUS connects fine and the heli controls work. However, the button to enable "VBar Control Telemetry" in the OMP app will not work. I updated my transmitter before installing this receiver. I have power cycled several times and deleted and reinstalled the app. Still the button for telemetry in the app will not work, it just goes back. No problem with the "S BUS range" which I set to Futaba, the button right above the telemetry button, which worked without problems. Is there something I need to check in macrocells? Did I perhaps get a flawed OMP control unit? Thank you. I updated the firmware and it works now! https://www.vstabi.info/forum/read.php?42,211149,211149#msg-211149 Mon, 14 Sep 2026 01:04:13 +0200 Phorum 5.2.7 https://www.vstabi.info/forum/read.php?42,211149,211150#msg-211150 https://www.vstabi.info/forum/read.php?42,211149,211150#msg-211150
As I see you figured it out by yourself already. :) (tu)]]> Aaronheli Café Wed, 24 Jun 2026 08:32:42 +0200 https://www.vstabi.info/forum/read.php?42,211149,211149#msg-211149 https://www.vstabi.info/forum/read.php?42,211149,211149#msg-211149

I updated the firmware and it works now!]]> Drav8r Café Tue, 23 Jun 2026 23:19:17 +0200